
Silicon Based Exterior Primer
July 12, 2024
Gross Concrete Primer
July 12, 2024Isolaque Primer
Acrylic copolymer based transparent wall coat for the gypsum and absorbent surfaces. Applied to the construction elements such as plaster concrete, gypsum, limestone, etc
PRODUCT DESCRIPTION & USE
Acrylic copolymer based transparent wall coat for the gypsum and absorbent surfaces. Applied to the construction elements such as plaster concrete, gypsum, limestone, etc
KEY BENEFITS
- Protects from rain, frost, snow and sunshine
- Protects from rain, frost, snow and sunshine, will not peel or flake
- Quick drying, low odor and VOC
- Shower proof in one hour
AVAILABLE IN SIZES
In 3.5 kg, 7.5 kg, 10 kg, 15 kg plastic buckets
COLOUR & GLOSS RANGE
Transparent, colourless
FLASH POINT
Not applicable since this product is non-flammable
VOC CONTENT
Lower than EU limits
COMPOSITION (Nominal)
Pigment: Lightfast pigment
Binder: Acrylic binder
Solvent: Water
SOLIDS – SPECIFIC GRAVITY
Volume Solids 25 ± 2 %
Specific Gravity 1 ± 0.05 gr/ml
SURFACE PREPARATION
The application surfaces should be cleaned from the dirt, oil, dust and all loosen structured swollen layers, the faults on the surface should be removed.
APPLICATION
Southwind Isolacque Primer is applied to the surface, penetrating it very well by thinned by 5-7 % with water. The last layer dye must be applied minimum after 6 hours
SPREADING RATE
0.02-0.03 kg/m2 depending on the surface’s situation
REDUCTION
5-7 % water may be added
DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)
Touch Dry At 20 °C 1/2 hours
Recoat 4 hours
This is dependent upon temperature and humidity
CLEANING UP
Clean up with soap and water. After cleaning up be sure to flush spray equipment with solvent to prevent rusting following manufacturer’s instructions. Dispose of buckets should be in accordance with local authority guidelines.
PRECAUTIONS / WARNINGS
Keep out of reach of children. Ensure good ventilation during application and drying. If the product comes in contact with the eyes rinse immediately with plenty of water. To remove splashes from skin, use soap and water or a recognized skin cleaner. Do not take internally.
STORAGE
The product should be kept in a dry place. Lid should be closed tight when not in use. Not to be exposed to direct sunlight. Stock life is 1 year in original container. Protect from freezing.
FOLLOW US ON
Online: www.southwindpaints.com
Email: info@southwindpaints.com
Phone: +90 530 429 9233
Reviews
There are no reviews yet.