Luxury Wall Plastic Paint
July 11, 2024
Water Based Satin Paint
July 11, 2024
Silicon Based Interior Paint
PVA emulsion based, effaceable satin matt last layer interior silicon additive. Applied to the surfaces of the construction elements such as cement coat, gypsum coat, plasterboard, gas concrete, brick, etc…
PRODUCT DESCRIPTION & USE
PVA emulsion based, effaceable satin matt last layer interior silicon additive. Applied to the surfaces of the construction elements such as cement coat, gypsum coat, plasterboard, gas concrete, brick, etc…
KEY BENEFITS
- Well adhesion to the surface,
- Higher coating,
- Washable,
- No fading or cracking.
AVAILABLE IN SIZES
In 3.5 kg, 10 kg, 20 kg, 25 kg plastic buckets
COLOUR & GLOSS RANGE
Various colour options, matt
FLASH POINT
Not applicable since it’s a non-flammable product
VOC CONTENT
Lower than EU limits
COMPOSITION (Nominal)
Pigment: Lightfast pigment
Binder: Acrylic binder
Solvent: Water
SOLIDS – SPECIFIC GRAVITY
Volume Solids 60±2%
Specific Gravity 1.5±0.05 gr/ml
SURFACE PREPARATION
The application surfaces should be cleaned from the dirt, oil, dust and all loosen structured swollen layers, the faults on the surface should be removed.
APPLICATION
Southwind Silicon Based Interior Paint is applied in two layers. 2 hours should be allowed between the layers. It is applied easily by fell roll or brush. It is recommended that it shall be applied between +5°C and 30°C.
SPREADING RATE
150-200 gr/m2 or 100-135 ml/m2 for double layer application,
depending on the surface condition
REDUCTION
Thinned with 15-20% water depending on the application surface.
DRYING TIMES (SINGLE COAT, STANDARD THICKNESS)
Touch Dry: At the 20 °C 1/2 hours
Recoat: 4hours
This is dependent upon temperature and humidity.
CLEANING UP
Clean up with soap and water. After cleaning up be sure to flush spray equipment with solvent to prevent rusting following manufacturer’s instructions. Dispose the bucket in accordance with local authority guidelines.
PRECAUTIONS / WARNINGS
Keep out of reach of children. Ensure good ventilation during application and drying. If the product comes in contact with the eyes rinse immediately with plenty of water. To remove splashes from skin, use soap and water or a recognized skin cleaner. Do not take internally.
STORAGE
The product should be kept in a dry place. Lid should be closed tight when not in use. Not to be exposed to direct sunlight. Stock life is 1 year in original container. Protect from freezing.
FOLLOW US ON
Online: www.southwindpaints.com
Email: info@southwindpaints.com
Phone: +90 530 429 9233
Reviews
There are no reviews yet.